Address Commands - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
Configuring OSPF attributes for OSPF networks includes setting the following:
NOTE: Before using the address or ip ospf commands, see "Precedence of
Commands" on page 266 for information about the relationship between these
commands.

address Commands

You can use the address area command to create a new OSPF interface. Use the
other address commands to configure parameters for OSPF interfaces that already
exist.
The address commands configure OSPF attributes for a single OSPF network. The
ip ospf commands configure OSPF attributes for all OSPF networks in the given
interface context for example, in a multinet environment where multiple IP networks
sit on top of an Ethernet interface.
NOTE: You must first issue the address area command before issuing any other
address command.
address area
address cost
258
Configuring OSPF Interfaces
Cost
Dead interval
Hello interval
Router priority
Retransmit interval
Transmit delay
Use to create a new OSPF interface and configure the area ID.
The interface can have an IP address, or it can be unnumbered.
Example
host1(config-router)#address 10.12.10.2 area 3
You must first issue the address area command before issuing any other address
commands.
Use the no version to delete the area ID from the specified interface.
See address area