Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 92

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
owner
request-data-size
tag
timeout
68
Response Time Reporter
Use the no version to return to the default, 3.
See operations-per-hop
Use to identify the owner of the probe.
If the SNMP agent is the owner of the probe, the owner's name can begin with
agent.
Example
host1(config-rtr)#owner 192.10.27.6 rtc.boston.com 555.1212
Use the no version to return to the default, no owner.
See owner
Use to set the protocol data size, in bytes, in the request packet.
Example
host1(config-rtr)#request-data-size 20
Use the no version to return to the default value, 1 byte.
See request-data-size
Use to set an identifier for the probe.
Example
host1(config-rtr)#tag westford
Use the no version to return to the default, no tag.
See tag
Use to set the time (in milliseconds) that the probe waits for a response.
You can apply this option only to an echo type.
Do not set the value for timeout to more than the value set for frequency. If you
do, the timeout value is ignored.
If you set the timeout to 0, no timeout is set.
Example
host1(config-rtr)#timeout 3000
Use the no version to return to the default value, 5000 milliseconds.
See timeout