Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 263

show ip rip summary-address
Received bad packets Number of bad packets received from the peer
Received bad routes Number of bad routes received from the peer
Triggered updates sent Number of triggered updates sent; triggered updates
are sent before the entire RIP routing table is sent; triggered by events such
as adding a new RIP route or redistribution
Received updates Number of updates received
Example 1
host1#show ip rip statistics
Number of route changes = 23
Number of route queries = 0
Example 2
host1#show ip rip statistics 10.2.1.32
Number of route changes = 901
Number of route queries = 0
fastEthernet 0/0, 10.2.1.32
Received bad packet = 0
Received bad routes = 0
Triggered updates sent = 2
Received updates = 41
See show ip rip statistics
Use to display the specified summary address or all summary addresses for RIP.
Field descriptions
Summary Address Address summarizing RIP routes
Mask Network mask specified in the ip summary-address command to
identify which routes to summarize
Metric Metric advertised with the summary RIP prefix
Example
host1#show ip rip summary-address
Summary Address Mask
4.3.0.0 255.255.0.0
4.4.0.0 255.255.0.0
See show ip rip summary-address
Chapter 4: Configuring RIP
Metric
3
5
Monitoring RIP
239