Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 319

remote-neighbor
retransmit-interval
transmit-delay
ttl
Example
host1(config-router-rn)#message-digest-key 42 md5 0 sal29ute
Use the no version to delete the MD5 key.
See message-digest-key md5
Use to configure an OSPF remote neighbor.
Use the update-source command to configure source IP address for packets
sent to the remote neighbor. We recommend that you do not leave the update
source unconfigured for a remote neighbor.
Example
host1(config-router)#remote-neighbor 10.25.100.14 area 35672
Use the no version to remove the remote neighbor and any attributes configured
for the remote neighbor.
See remote-neighbor
Use to set the time between LSA retransmissions for the OSPF remote-neighbor
interface when an acknowledgment for the LSA is not received.
Specify a value in the range 1–3600 seconds; the default value is 5 seconds.
Example
host1(config-router-rn)#retransmit-interval 10
Use the no version to restore the default value, 5 seconds.
See retransmit-interval
Use to set the estimated time it takes to transmit a link-state update packet on
the OSPF remote-neighbor interface.
Specify a value in the range 0–3600 seconds; the default value is 1 second.
Example
host1(config-router-rn)#transmit-delay 3
Use the no version to restore the default value, 1 second.
See transmit-delay
Chapter 5: Configuring OSPF
295
Remote Neighbors