Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 142

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
118
Monitoring IP
PRU_FASTTIMO: 0
PRU_SLOWTIMO: 0
PRU_PROTORCV: 0
PRU_PROTOSEND: 0
Wildcard Matches: 2
Rcv'd Packets after connection closed: 0
Connect request rejected: 0
Connect request approval pending 0
New soconnect failed 0
# Write-Wakeups: 0
# Read wakeups 0
# receives after close 0
Retransmit timer: 0
Persistance timer: 0
Keepalive timer: 0
2MSL timer: 0
tcpDisconnect()s: 0
keep T/O pre-estab: 0
tcpkeeptimeo_idle: 0
...
TCP Connection Event Log (most recent at bottom)
TCPS_ELOG_PRU_ATTACH
TCPS_ELOG_PRU_BIND
Example 3 Additional fields displayed by detailed keyword
host1#show ip tcp statistics detailed
...
RST/SYN-Ack Protection is: ENABLED
RSTs acked: 0
...Bogus RSTs: 0
SYNs acked: 0
...Bogus SYNs: 0
Data Insertions rejected: 0
PMTUD Information:
Administrative Minimum MTU: 512
Administrative Maximum MTU: none
Timer 1: 10 minutes
Timer 2: 2 minutes
# ICMP TooBigs: 0
# ICMP TooBigs for unk. connection: 0
PMTU Increase Attempts: 17
Black Hole Detect Threshold: 50 retransmissions
...
MTU/MSS Information
ENABLED on this connection
MSS in effect: 536
Calculated MSS to peer: 536
MSS received from peer: 0
Application set MSS: 0
Xmit Interface MSS: 0
MSS Sent to Peer: 0
"ICMP DestUn, Frag Req'd and DF Set" messages: 0
Number of attempts to increase PMTU: 0
Time to next increase attempt: 0 seconds
Black Hole Detection State: none
...
Out-of-order Packet Queue Information
PMTUD: ENABLED