Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 434

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
show clns traffic
410
Monitoring IS-IS
host1:2#show clns protocol
IS-IS Router:
System Id: 0040.0400.4002.00
Operational State: Up
Manual area address(es):
49.0001
Routing for area address(es):
49.0001
Interfaces supported by IS-IS:
loopback1 - IP
FastEthernet1/1 - IP,IPv6
ATM3/1.1 - IP, IPv6
Distance: 115
Redistributing:
static
See show clns protocol
Use to display all CLNS packets the router sees.
Use the optional delta keyword to specify that baselined statistics are to be
shown.
Field descriptions
IS-IS: Baseline last set Time since the baseline was set
IS-IS: Corrupted LSPs Number of LSPs received with errors
IS-IS: L1 LSP Database Overloads Number of overloads in level 1
IS-IS: L2 LSP Database Overloads Number of overloads in level 2
IS-IS: Area Addresses Dropped Number of area addresses that the router
dropped
IS-IS: Attempts to Exceed Max Sequence Number of sequence wraps over
maximum
IS-IS: Sequence Numbers Skipped Number of LSPs received out of order
IS-IS: Own LSPs Purged Number of LSPs deleted
IS-IS: Other LSPs Purged Number of received LSPs deleted
IS-IS: System ID Length Mismatches Number of unmatched system ID
lengths
IS-IS: Maximum Area Mismatches Number of rejected hellos due to area
mismatches
IS-IS: Area/Domain Authentication Failures Number of authentication
failures on received level 1 and level 2 LSP/SNPs
IS-IS: Level-1 LSPs Sent Rcvd Dropped Number of level 1 LSPs sent,
received, and dropped
IS-Type: level-1-2