Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 341

show ip ospf internal-statistics
show ipv6 ospf internal-statistics
Example 2
host1#show ipv6 ospf interface
ATM4/0.12 is up, OSPFv3 line protocol is up
Area 0.0.0.0, Intf ID: 0x320004, Instance ID: 0
Link Local Address: fe80::90:1a00:100:80
Interface is active
Network type POINT-TO-POINT
Interface State POINT-TO-POINT
Cost: 1, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured:
Hello 10, Dead 40, Wait 40
Transmit Delay is 1 sec(s)
Retransmit interval is 5 secs
Neighbor Count is 1
FULL Adjacent neighbor count is 1
Adjacent with neighbor 11.0.0.2
FastEthernet0/0 is up, OSPFv3 line protocol is up
OSPF interface configuration:
Interface ID 0.0.1.1
IPv6 link-local address FE80::3/128
IPv6 prefix address 3000::1/64, Area 0.0.0.0
Network type BROADCAST
Cost: 1
Transmit Delay is 1 sec, Interface State BACKUPDR, Priority 1
Designated Router's router ID 1.1.1.1
Backup Designated Router's router ID 2.2.2.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 3.3.3.3 (Designated Router)
See show ip ospf interface
See show ipv6 ospf interface
Use to display internal OSPFv2 or OSPFv3 statistics, such as allocation failures
for different OSPF components.
Use the delta keyword to display statistics relative to the current baseline.
Field descriptions
LSA bytes allocated Number of bytes allocated for LSAs
Router LSA bytes allocated Number of bytes allocated for router LSAs
Summary bytes allocated Number of bytes allocated for summary LSAs
Neighbor RTX bytes allocated Number of bytes allocated for neighbor
retransmissions
Timers bytes allocated Number of bytes allocated for OSPF timers
Ospf total bytes free Total number of bytes free
Chapter 5: Configuring OSPF
317
Monitoring OSPF