Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 131

show ip static
host1#show ip static
Prefix/Length Next Hop
1.1.1.2/32 1.1.1.2
1.1.1.2/32 1.1.1.2
so_RecvMsgs = 0
so_Reads = 0
Socket Event Log (most recent at bottom)
rssocket
sobind - 0
bind - 0
solisten - 0
listen - 0
See show ip socket statistics
Use to display the status of static routes in the routing table.
You can specify an IP mask that filters specific routes.
Field descriptions
Prefix IP address prefix
Length Prefix length
Next Hop IP address of the next hop
Met Number of hops
Dist Administrative distance of the route; see Table 5 on page 27
Tag Tag value of the route
Intf Interface type and interface specifier
Verify Status of the RTR or BFD operation associated with the specified
static route; this field is blank if the verify (BFD) or verify rtr (RTR) keywords
were not specified as part of the ip route command. The display can include
the following:
BFD up/down Current status of the associated BFD operation
operation number Number of the associated RTR operation
up/down Current status of the associated RTR operation
(lr) Indicates that although the associated RTR operation is currently
down, the router will install this route in the routing table, provided that
no other static route to the same network prefix is available; this field
appears for an RTR operation that is down when the last-resort keyword
is specified as part of the ip route verify rtr command
Example
Met Dist Tag Intf
0 1 0 FastEthernet4/0
0 1 0 FastEthernet4/1
Chapter 1: Configuring IP
Verify
2 up
Monitoring IP
107