Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 385

clear ip isis redistribution
clear isis ipv6 redistribution
disable-dynamic-redistribute
redistribute
Metric: 30 IP 10.20.21.0 255.255.255.0
Metric: 30 IP 10.20.20.0 255.255.255.0
Use the no version of the access-list command to remove the access list or the
specified entry in the access list.
Use the no version of the route-map command to remove an entry.
See access-list
See route-map
Use to clear all the routes that have been previously redistributed into IS-IS and
to redistribute them using the current policy configured. Use the IP version to
redistribute IP routes. Use the IPv6 version to redistribute IPv6 routes.
Use when you have made changes to route maps or access lists that affect how
routes are redistributed to IS-IS.
Example
host1#clear ip isis redistribution
There is no no version.
See clear ip isis redistribution
See clear isis ipv6 redistribution
Use to halt the dynamic redistribution of routes that are initiated by changes to
a route map.
Dynamic redistribution is enabled by default.
Example
host1(config-router)#disable-dynamic-redistribute
Use the no version to reenable dynamic redistribution.
See disable-dynamic-redistribute
Use to redistribute routes from other routing protocols in the routing table to
IS-IS. IS-IS advertises these routes as level 1 only, level 2 only, or both. Level 2
only is the default.
To redistribute IPv6 routes, you must issue the command from within the IS-IS
IPv6 address family.
The default is no source protocol defined for redistribution.
This command can accomplish the same results as the passive-interface
command by redistributing a connected route to level 1.
Chapter 6: Configuring IS-IS
Configuring Global IS-IS Parameters
361