Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 236

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
10.
NOTE: For information about the ip prefix-tree command, see JUNOSe IP Services
Configuration Guide.
11.
12.
13.
14.
15.
16.
17.
212
Configuration Tasks
(Optional) Summarize routes.
Use a prefix tree to specify the number of bits to report for routes matching a
route map:
host1(config)#ip prefix-tree boston permit 10.10.2.0/24
host1(config-router)#route-map 4
host1(config-route-map)#match-set summary prefix-tree boston
Alternatively, explicitly specify routes for RIP to summarize:
host1(config-router)#ip summary-address 4.4.0.0 255.255.0.0 5
host1(config-router)#ip summary-address 4.3.0.0 255.255.0.0 6
(Optional) Redistribute routes from other protocols into RIP, or from RIP to other
protocols.
host1(config-router)#redistribute rip 5
host1(config-router)#route-map 4
host1(config-router)#redistribute bgp 100 route-map 4
(Optional) Enable unicast communication with RIP neighbors.
host1(config-router)#neighbor 10.10.21.100
host1(config-router)#passive-interface atm atm 2/0.16
(Optional) Set the debounce time for interfaces brought down by some event.
host1(config-router)#debounce-time 30
(Optional) Prevent RIP from purging the routing table for interfaces brought
down by some event.
host1(config-router)#interface-event-disable
(Optional) Prevent RIP from sending a more-specific route if a less-specific route
has a better metric.
host1(config-router)#send-more-specific-routes-disable
(Optional) Prevent RIP from sending triggered updates.
host1(config-router)#triggered-update-disable
(Optional) Apply a table map to modify route distance.
host1(config-router)#table-map dist1