Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 99

show rtr configuration
operStatus Operational status of the probe: enabled, disabled
minRtt Minimum round-trip time in milliseconds
maxRtt Maximum round-trip time in milliseconds
avgRtt Average round-trip time in milliseconds
rttSumSqr Sum of the square of all round-trip times in milliseconds
testAttempts Number of times the test ran
testSuccesses Number of times the test ran successfully
currentHop Current hop (TTL) used in the test
currentOperation Current probe operation index sent to the hop
Example
host1#show rtr collection-statistics
Echo Entries:
rtrIndex operationsSent
---------- --------------
1 5208
rtrIndex operStatus
---------- ----------
1 enabled
PathEcho Entries:
rtrIndex testAttempts
---------- ------------
2 156
rtrIndex operStatus
---------- ----------
2 enabled
See show rtr collection-statistics
Use to display the configuration for a particular probe or for all probes.
Field descriptions
rtrIndex Index number of the RTR probe
type Probe type: echo, pathEcho
targetAddress Address of the probe's target
reqSize Protocol data size in the request packet
freq Rate in seconds that the RTR probe uses to start a response time
operation
operationsRcvd lastGoodResponse
-------------- ----------------
5187 08/30/2000 05:09
minRtt maxRtt avgRtt rttSumSqr
------ ------ ------ ---------
0 1785 3 7109208
testSuccesses lastGoodResponse
------------- ----------------
156 08/30/2000 05:09
currentHop currentOperation
---------- ----------------
2 4
Response Time Reporter
Chapter 1: Configuring IP
75