Table of Contents
Advertisement
maximum-paths
ospf bandwidth
ospf shutdown
passive-interface
See log-adjacency-changes
See ospf log-adjacency-changes
Use to control the maximum number of parallel routes that OSPF can support.
The maximum number of routes can be in the range 1–16.
The default for OSPF is 4 paths.
To enable equal-cost multipath (ECMP) for OSPF, you need to specify a value for
maximum paths greater than 1.
Example
host1(config-router)#maximum-paths 2
Use the no version to restore the default value, 4.
See maximum-paths
Use to direct the router to use the bandwidth configured on an OSPF interface
as part of its calculation of the OSPF interface cost.
The router uses various methods and precedence rules for the commands to
calculate the OSPF interface cost. For information on the precedence based on
the commands you use, see "Methods for Calculating OSPF Interface Cost" on
page 287.
Example
host1(config-router)#ospf bandwidth
Use the no version to disable the use of the configured bandwidth for OSPF
interface cost calculation.
See ospf bandwidth
Use to administratively disable OSPF on the router.
Example
host1(config-router)#ospf shutdown
Use the no version to reenable OSPF on the interface.
See ospf shutdown
Chapter 5: Configuring OSPF
Configuring Additional Parameters
285
Advertisement
Table of Contents
