Establishing A Baseline - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
For more information about using event logs, see the JUNOSe System Event Logging
Reference Guide.

Establishing a Baseline

IP statistics are stored in system counters. The only way to reset the system counters
is to reboot the router. You can, however, establish a baseline for IP statistics by
setting a group of reference counters to zero.
baseline ip
baseline ip udp
80
Monitoring IP
ipGeneral IP general information
ipIfCreator IP interface creator events
ipInterface IP interface events
ipNhopTrackerGeneral Next-hop tracker for IP shared interfaces
ipProfileMgr IP profile manager events
ipRoutePolicy IP routing policy events
ipRouteTable IP routing table events
ipTraffic IP frame transmit and receive events
ipTunnel IP tunnel events
Use to set a statistics baseline for IP statistics. Baselining is not supported for IP
socket statistics.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Use the delta keyword with IP show commands to specify that baselined statistics
are to be shown.
Example
host1#baseline ip
There is no no version.
See baseline ip
Use to set a statistics baseline for UDP statistics.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Use the delta keyword with IP show commands to specify that baselined statistics
are to be shown.
Example
host1#baseline ip udp