Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 413

debug isis
show hosts
Use to obtain debug-related information about certain parameters.
This command manipulates the same log as the Global Configuration log
commands.
You can select from these parameters:
adj-packets IS-IS adjacency-related packets
mpls traffic-eng advertisements MPLS traffic-engineering agent
advertisements
mpls traffic-eng agents MPLS traffic-engineering agents
snp-packets IS-IS CSNP/PSNP packets
spf-events IS-IS Shortest Path First events
spf-statistics IS-IS SPF timing and statistic data
spf-triggers IS-IS SPF triggering events
update-packets IS-IS update-related packets
Example
host1#debug isis adj-packets
Use the no version to disable debugging display.
See debug isis
Use to display the name-to-NSAP mappings defined with the clns host command.
Field descriptions
Static Host Table
name Name assigned to the host
ip address Host IP address
type Type of host
username Username necessary to access the host
password Password necessary to access the host
Clns Host Alias Table
name Name of the host alias
area address Area address of the host alias
system ID Six-byte value of the host alias
type Type of host alias
Chapter 6: Configuring IS-IS
389
Monitoring IS-IS