Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 345

show ip ospf spf-log
Priority Priority value for this interface
Designated router Designated router on this network, if any
Backup designated router Backup designated router on this network, if any
Hello Hello timer value, in seconds
Dead Dead interval timer value, in seconds
Wait Wait interval timer value, in seconds
Retransmit Retransmit interval timer value, in seconds
Neighbor Count Number of neighbors to this interface
Adjacent neighbor count Number of adjacent neighbors to this interface
Adjacent with neighbor Address of the neighbor adjacent to this interface
Example
host1#show ip ospf remote-neighbor interface
OSPF remote-neighbor 221.221.221.221 interface configuration:
Update-source loopback0
Remote-neighbor reachable: yes
Area 0.0.0.0
Network type POINT-TO-POINT, No authentication
Cost: 1
Transmit Delay is 1 sec, Interface State POINT-TO-POINT, Priority 1
No designated router on this network
No backup designated router on this network
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 221.221.221.221
See show ip ospf remote-neighbor interface
Use to display how often and why the router has run a full SPF calculation.
Field descriptions
Intra SPF log Log for SPF calculations run to compute intra-area LSAs
Inter SPF log Log for SPF calculations run to compute interarea LSAs
External SPF log Log for SPF calculations run to compute routes outside
the OSPF routing domain
When Amount of time since a full SPF calculation took place, in
hours:minutes:seconds; the previous 20 calculations are logged
Duration Number of milliseconds to complete this SPF run; the elapsed
time is in actual clock time, not CPU time
Chapter 5: Configuring OSPF
321
Monitoring OSPF