Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 110

Software for e series broadband services routers ip, ipv6, and igp configuration guide
Table of Contents

Advertisement

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
show ip as-path-access-list
86
Monitoring IP
Out Scheduler Drops Exceeded Packets, Bytes Outgoing packets and bytes
that were dropped by the scheduler because they exceeded the contract
Out Policed Packets, Bytes Outgoing packets and bytes dropped because
of rate limiters
Out Discarded Packets Outgoing packets that were discarded for reasons
other than those dropped by the scheduler and those dropped because of
rate limits
Example
host1#show ip address 10.6.136.73
fastEthernet0/0 is up, line protocol is up
Network Protocols: IP
Internet address is 10.6.136.73/255.255.128.0
Broadcast address is 255.255.255.255
Operational MTU = 0
Operational speed = 1
Discontinuity Time = 5766
Router advertisement = disabled
Proxy Arp = disabled
Administrative debounce-time = 10 mSecs
Operational debounce-time
Access routing = disabled
Multipath mode = hashed
In Received Packets 2849, Bytes 759428
Unicast Packets 2849, Bytes 759428
Multicast Packets 0, Bytes 0
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
In Discarded Packets 0
Out Forwarded Packets 1866, Bytes 84650
Unicast Packets 1866, Bytes 84650
Multicast Routed Packets 0, Bytes 0
Out Scheduler Drops Committed Packets 0, Bytes 0
Out Scheduler Drops Conformed Packets 0, Bytes 0
Out Scheduler Drops Exceeded
Out Policed Packets 0, Bytes 0
Out Discarded Packets 0
See show ip address
Use to display information about AS-path access lists.
Example
host1#show ip as-path-access-list
AS Path Access List 1:
permit
.*
AS Path Access List 2:
deny
.*
AS Path Access List 3:
permit
_109_
Administrative MTU = 0
Administrative speed = 0
= disabled
Packets 0, Bytes 0

Advertisement

Table of Contents
loading

Table of Contents