Shutting Down The Probe - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

rtr schedule restart-time
rtr schedule start-time

Shutting Down the Probe

You can shut down the RTR probe operation.
rtr reset
Use to schedule the test's length.
Life is a value that depends on the type of the RTR entry; it is not a length of
time.
If the type is echo, life relates to the number of probes sent until a test
finishes.
If the type is pathEcho, life relates to the maximum number of hops used
by the traceRoute trap.
Example
host1(config)#rtr schedule 5 life 1800
Use the no version to stop the test. The no version stops the probe operation by
putting it in the pending state. The no version also resets the life attribute.
See rtr schedule life
Use to specify a restart time, in seconds, after which a test is restarted.
Example
host1(config)#rtr schedule 5 restart-time 15
Use the no version to stop the test. The no version stops the probe operation by
putting it in the pending state. The no version also resets the restart-time attribute.
See rtr schedule restart-time
Use to schedule a test's starting time (now or pending).
Example
host1(config)#rtr schedule 5 start-time now
Use the no version to stop the test. The no version stops the probe operation by
putting it in the default state, pending.
See rtr schedule start-time
Chapter 1: Configuring IP
Response Time Reporter
73