Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 258

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
234
Monitoring RIP
host1#show ip rip
Routing Information Protocol
Router Administrative State = enable
System version RIP2: send = 2, receive = 2
No filter is applied to outgoing route update for all interfaces
No filter is applied to incoming route update for all interfaces
No global route map
No table map
Default metric = 1
Distance = 120
Number of route changes = 3
Number of route queries = 0
Update interval = 30 (secs)
Invalid interval = 180 (secs)
Hold down time = 120 (secs)
Flush interval = 300 (secs)
Route Type = both unicast and multicast
Max Ecmp Paths = 4
Default-Information originate always = enabled
Triggered Updates = enabled
Purge Routes on Interface Down Event
Send More Specific Routes
Debounce Time = 10
Default-Information originate : disabled
route-map : none
Summary Address: None
Network netmask
Neighbor
No Configured Neighbors
*** Address Operational Data ***
Unnumbered, Rip is up, ATM2/1.18
Dynamic creation and inherits configuration from loopback1
Received bad packet = 0
Received bad routes = 0
Triggered updates sent = 0
Received updates = 9
1.1.1.1, Rip is up, loopback1
Send version = 2
Receive version = 2
Authentication mode = none
Default metric = 1
Passive Interface = No
Access-list applied to outgoing route = none
Access-list applied to incoming route = none
Route-map applied to outgoing route = none
Copy configuration to dynamic interfaces
Received bad packet = 0
Received bad routes = 0
Triggered updates sent = 0
Received updates = 0
Example 2
host1#show ip rip ifconfig
Routing Information Protocol
Router Administrative State = enable
System version RIP2: send = 2, receive = 2
No filter is applied to outgoing route update for all interfaces
No filter is applied to incoming route update for all interfaces
= enabled
= enabled