Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 419

Use to display the last record flooded from MPLS.
Field descriptions
System ID Name or system ID of the MPLS tail-end (destination) router
Router ID Router ID for the router
Link Count Number of links that MPLS advertises
Neighbor System ID Identifier of the remote system in an area
Administrative group TLV administrative group or color assigned to the
link
Interface IP address IP address of the interface
Neighbor IP Address IP address of the neighbor
Maximum link bandwidth Bandwidth capacity of the link in bits per second
Reservable link bandwidth Amount of bandwidth reservable on the link
(whether reserved or not)
Unreserved bandwidth Amount of bandwidth available for reservation on
the link
TE default metric Traffic engineering default metric value
Affinity Bits Attributes flooded for the link
Example
host1#show isis mpls advertisements
System ID: zion.00
Router ID: 222.9.1.1
Link[1]
Neighbor System ID: london.00
Administrative group:
IPv4 Interface Address:
IPv4 Neighbor Address:
Maximum link bandwidth:
Reservable link bandwidth:
Unreserved bandwidth:
Priority 0:
Priority 1:
Priority 2:
Priority 3:
Priority 4:
Priority 5:
Priority 6:
Priority 7:
TE default metric:
Link[2]
Neighbor System ID: london.00
Administrative group:
IPv4 Interface Address:
IPv4 Neighbor Address:
Maximum link bandwidth:
Reservable link bandwidth:
Unreserved bandwidth:
0
221.1.1.1
221.1.1.2
50000
50000
50000
50000
50000
50000
30000
30000
30000
30000
0
0
221.1.6.1
221.1.6.2
50000
50000
Chapter 6: Configuring IS-IS
395
Monitoring IS-IS