Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 223

ipv6 nd prefix-advertisement
ipv6 nd ra-interval
ipv6 nd ra-lifetime
ipv6 nd reachable-time
Use the no version of this command to clear the flag from IPv6 router
advertisements.
See ipv6 nd other-config-flag
Use to specify which IPv6 prefixes the system includes in IPv6 router
advertisements.
Example
host1(config-if)#ipv6 nd prefix-advertisement 2002:1::/64 60000 45000 onlink
autoconfig
Use the no version of this command to remove any prefixes from the IPv6 routing
advertisements.
See ipv6 nd prefix-advertisement
Use to specify the interval, in seconds, between IPv6 router advertisement
retransmissions on an interface.
Example
host1(config-if)#ipv6 nd ra-interval 500
Use the no version of this command to restore the default interval,
200 seconds.
See ipv6 nd ra-interval
Use to specify the router lifetime value, in seconds, in IPv6 router advertisements
on an interface. The router lifetime value is the amount of time the router is
considered the default router on this interface.
Example
host1(config-if)#ipv6 nd ra-lifetime 900
Use the no version of this command to restore the default lifetime,
1800 seconds.
See ipv6 nd ra-lifetime
Use to specify the amount of time that the E Series router can reach a remote
IPv6 node after some reachability confirmation event has occurred.
Example 1 Sets the reachable-time to 30,000 milliseconds
Chapter 3: Configuring Neighbor Discovery
Configuring Neighbor Discovery
199