Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 119

show ip profile
ip si1 is up, line protocol is up
Network Protocols: IP
Virtual Router vr-b:vrf-1
Layer 2 interface atm4/0.1
.
.
.
Out Policed Packets 0, Bytes 0
Example 4
host1#show ip interface shares ip si0
ip0 is up, line protocol is up
Network Protocols: IP
Layer 2 interface atm4/0.1
Unnumbered Interface on loopback100
( IP address 202.1.1.1 )
Operational MTU = 1500
Operational speed = 155520000
Discontinuity Time = 0
Router advertisement = disabled
Administrative debounce-time = disabled
Operational debounce-time
Access routing = disabled
Multipath mode = hashed
In Received Packets 0, Bytes 0
Unicast Packets 0, Bytes 0
Multicast Packets 0, Bytes 0
In Policed Packets 0, Bytes 0
In Error Packets 0
In Invalid Source Address Packets 0
Out Forwarded Packets 101, Bytes 5252
Unicast Packets 101, Bytes 5252
Multicast Routed Packets 0, Bytes 0
Out Scheduler Drops Committed Packets 0, Bytes 0
Out Scheduler Drops Conformed Packets 0, Bytes 0
Out Scheduler Drops Exceeded
Out Policed Packets 0, Bytes 0
See show ip interface shares
Use to display information about a specific IP profile.
Field descriptions
IP profile Profile name
IP address IP address and subnet mask of the interface or none if the
interface is unnumbered
Unnumbered interface Specifier for the unnumbered interface or none if
the interface is numbered
Router Router name
Directed Broadcast Enabled or disabled
Administrative MTU = 0
Administrative speed = 0
= disabled
Packets 0, Bytes 0
Chapter 1: Configuring IP
95
Monitoring IP