Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 202

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
178
Monitoring IPv6
Use to display the current state of the routing table, including routes not used
for forwarding.
You can display all routes, a specific route, detailed information about all or a
specific route, or summary counters for the routing table.
Field descriptions
Prefix IPv6 address prefix
Length Prefix length
Type Protocol type (possible route types include: Bgp, Connect, Idrp, Igrp,
Invalid, Isis, Ndisc, Ospf, Other, Rip, Static)
Dst (or Distance) Administrative distance for the route
Met (or Metric) Number of hops
Intf (or Interface) Interface type and interface specifier
NextHop The configured next hop address for this interface
IfIndex An autogenerated value for the next hop interface
Example 1
host1#show ipv6 route
Prefix/Length
-------------------------------- ------- ------- --------------------
1::/16
5::/64
6::/64
2003::/16
Example 2
host1#show ipv6 route summary
Unicast routes:
8 total routes, 576 bytes in route entries
0 isis routes
0 rip routes
3 static routes
2 connected routes
1 bgp routes
0 ospf routes
2 other internal routes
0 access routes
0 internally created access host routes
Last route added/deleted: 2::4/128 by BGP
At MON FEB 04 2008 14:18:25 UTC
Unicast routes used only for Multicast RPF check:
0 total routes, 0 bytes in route entries
0 isis routes
0 rip routes
0 static routes
0 connected routes
0 bgp routes
0 ospf routes
Type Dst/Met Intf
Connect 0/0 loopback1
Connect 0/0 ATM4/0.15
Static 1/0 ATM4/0.15
Static 1/0 ATM4/0.15