Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 260

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
show ip rip brief
show ip rip database
236
Monitoring RIP
host1#show ip rip ifconfig
*** Interface Configuration Data***
FastEthernet1/0
Send version = def
Receive version = def
Authentication mode = none
Default metric = default
BFD minimum receive interval(msec) =
BFD minimum transmit interval(msec)= 500
BFD multiplier = 2
Passive Interface = No
Access-list applied to outgoing route = none
Access-list applied to incoming route = none
Route-map applied to outgoing route = none...
See show ip rip
Use to display limited RIP information.
Specify vrf vrfName to limit the display to a specific VRF.
Field descriptions
IP Address IP address of the interface where RIP is running
Tx Transmit version of RIP on this interface, which can override the router
configuration
Rx Receive version of RIP on this interface
Auth Type of authentication, password (text) or MD5
Met Current value is the same as the router one (the default metric). Based
on MIB 2 for RIP, the interface's route metric can be set individually.
AccList O/I Access list applied to outgoing/incoming RIP route updates
RtMap Identifier for the route map that specifies a summary of RIP routes
Status Status of RIP, either up or down
Intf Interface type on which RIP is running
Example
host1#show ip rip brief
IP Address Tx Rx Auth
10.2.1.32 1 1,2 none
10.10.1.2 1 1,2 none
See show ip rip
Use to display the route entries in the RIP routing table.
Specify vrf vrfName to limit the display to a specific VRF.
400
Met AccList O/I RtMap Status Intf
1 no/no no up fastEthernet0/0
1 no/no no up serial5:1/1:1