Clearing Dvmrp Routes; Configuring Dvmrp Tunnels; Monitoring Dvmrp - Juniper JUNOSE 11.1.X MULTICAST ROUTING Configuration Manual

JUNOSe 11.1.x Multicast Routing Configuration Guide

Clearing DVMRP Routes

You can clear one or more routes from the DVMRP routing table. However, if you
do so, the routes might reappear in the routing table if they are rediscovered.
clear ip dvmrp routes

Configuring DVMRP Tunnels

DVMRP tunnels enable the exchange of IP multicast traffic between routers separated
by networks that do not support multicast routing. For information about DVMRP
tunnels, see Configuring IP Tunnels in the JUNOSe IP Services Configuration Guide.

Monitoring DVMRP

You can establish a reference point for DVMRP statistics by setting the statistics
counters to zero.
You can display DVMRP information with the show ip dvmrp commands.
baseline ip dvmrp
136

Clearing DVMRP Routes

Use to create and enable DVMRP processing on a VR or to access Router
Configuration mode.
Example
host1:boston(config)#router dvmrp
Use the no version to remove DVMRP from a VR.
See router dvmrp.
Use to clear DVMRP routes from the routing table.
If you do not specify any options, the router removes all routes except those
associated with its own interfaces from the DVMRP table.
If you specify an IP address but not a subnet mask, the router removes the longest
route to that IP address from the DVMRP table.
If you specify a subnet mask, the router removes that specific route from the
DVMRP table.
Example
host1:boston#clear ip dvmrp routes
There is no no version.
See clear ip dvmrp routes.