Establishing A Static Route; Specifying An Ipv6 Hop Count Limit - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
ipv6 sa-validate

Establishing a Static Route

You can set a destination to receive and send traffic by a specific route through the
network.
ipv6 route

Specifying an IPv6 Hop Count Limit

You can specify the maximum number of hops that the router can use in router
advertisements and all IPv6 packets.
ipv6 hop-limit
138
Establishing a Static Route
Use to enable source address validation. Source address validation verifies that
a packet has been sent from a valid source address.
Example
host1(config-if)#ipv6 sa-validate
Use the no version to disable source address validation.
See ipv6 sa-validate
Use to establish a static IPv6 route.
You can set a destination to receive and send traffic from and to a network or
to use a specific route through the network.
Example
host1(config)#ipv6 route 7fff::0/16 1::1
Use the no version of this command to remove a static route from the routing
table.
See ipv6 route
Use to set the maximum number of hops that the router can use in router
advertisements and all IPv6 packets.
Example
host1(config)#ipv6 hop-limit 50
Use the no version to set the hop limit for IPv6 packets to 255 hops and router
advertisements to zero (0) hops (or " unspecified" ).
See ipv6 hop-limit