Clearing Dvmrp Routes - Juniper JUNOSE 11.2.X MULTICAST ROUTING Configuration Manual

ip dvmrp
ip dvmrp disable
router dvmrp

Clearing DVMRP Routes

clear ip dvmrp routes
Copyright © 2010, Juniper Networks, Inc.
Use to disable DVMRP processing on a VR without removing the DVMRP configuration.
By default, DVMRP processing is enabled.
Example
host1:boston(config-router)#disable
Use the no version to reenable DVMRP processing on a VR.
See disable.
Use to activate DVMRP on an interface.
This command automatically creates and enables DVMRP processing on the current
VR.
Issue this command to identify this interface as one that DVMRP owns.
Example
host1:boston(config-if)#ip dvmrp
Use the no version to remove DVMRP from an interface.
See ip dvmrp.
Use to disable DVMRP processing on an interface without removing the DVMRP
configuration.
Example
host1:boston(config-if)#ip dvmrp disable
Use the no version to reenable DVMRP processing on an interface.
See ip dvmrp disable.
Use to create and enable DVMRP processing on a VR or to access Router Configuration
mode.
Example
host1:boston(config)#router dvmrp
Use the no version to remove DVMRP from a VR.
See router dvmrp.
You can clear one or more routes from the DVMRP routing table. However, if you do so,
the routes might reappear in the routing table if they are rediscovered.
Chapter 4: Configuring DVMRP
131