Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 331

Chapter 5: Configuring OSPF
Seq# Link-state sequence number (detects old or duplicate LSAs)
Checksum Fletcher checksum of the complete contents of the LSA
Area Area for which data is displayed
Router Number of router LSAs
Network Number of network LSAs
Intra-Prefix Number of intra-prefix LSAs
Inter-Prefix Number of inter-prefix LSAs
Inter-Router Number of inter-outer LSAs
Link LSAs Number of link LSAs
Grace LSAs Number of graceful restart LSAs
External LSAs Number of external LSAs
MaxAge Number of LSAs that have reached the maximum age
Area Area for this LSA
LS age LSA age
Options Optional capabilities supported by this router
LS Type LSA type
Link State ID Link-state ID of the link local LSA
Length Length of the LSA (in bytes)
Bit set Bit set used by this LSA type
Link connected to Type of network to which the link connects
Neighboring router's Router ID Router ID of the neighboring router
Neighboring router's Interface ID Interface ID of the neighboring router
Local Interface ID Local interface ID
Metric Cost of this interface
Attached Router Addresses of any attached routers
Router Priority Priority value configured for the router
Link Local Address Originating router's link-local interface address on the
link
Prefixes Prefixes associated with this LSA
Number of Prefixes Number of prefixes associated with this LSA
307
Monitoring OSPF