Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual page 178

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide
baseline ipv6 local pool
baseline tcp
154
Monitoring IPv6
Use to set a statistical baseline for a specified IPv6 interface.
Example
host1#baseline ipv6 interface atm 2/0.100
There is no no version.
See baseline ipv6 interface
Use to set a baseline for IPv6 local address pool statistics used in DHCP prefix
delegation.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Example
host1#baseline ipv6 local pool
There is no no version.
See baseline ipv6 local pool.
Use to set a statistics baseline for all (both IPv4 and IPv6) TCP statistics or for
only IPv4 or IPv6 statistics.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Use the ipv6 keyword to implement a baseline for only IPv6 statistics.
Use the delta keyword with IP show commands to specify that baselined statistics
are to be shown.
Example 1
host1#baseline tcp
Example 2
host1#baseline ipv6 tcp
There is no no version.
See baseline tcp