NETGEAR ProSafe GSM7228PS Cli Manual page 356

1 packets transmitted,0 packets received, 100% packet loss
round-trip (msec) min/avg/max = 0/0/0
quit
This command closes the current telnet connection or resets the current serial connection. The
system asks you whether to save configuration changes before quitting.
Format
quit
Modes • Privileged EXEC
• User EXEC
reload
This command resets the switch without powering it off. Reset means that all network connections
are terminated and the boot code executes. The switch uses the stored configuration to initialize
the switch. You are prompted to confirm that the reset should proceed. The LEDs on the switch
indicate a successful reset.
Format
reload
Mode Privileged EXEC
save
This command makes the current configuration changes permanent by writing the configuration
changes to system NVRAM.
Format
save
Mode Privileged EXEC
Utility Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
7-30