NETGEAR ProSafe GSM7228PS Cli Manual page 196

lldp transmit
Use this command to enable the LLDP advertise capability.
Default enabled
Format
lldp transmit
Mode Interface Config
no lldp transmit
Use this command to return the local data transmission capability to the default.
Format
no lldp transmit
Mode Interface Config
lldp receive
Use this command to enable the LLDP receive capability.
Default enabled
Format
lldp receive
Mode Interface Config
no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Format
no lldp receive
Mode Interface Config
lldp timers
Use this command to set the timing parameters for local data transmission on ports enabled for
LLDP. The <interval-seconds> determines the number of seconds to wait between
transmitting local data LLDPDUs. The range is 1-32768 seconds. The <hold-value> is the
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-158