Dos-Control Icmpv - NETGEAR ProSafe GSM7228PS Cli Manual

Format
dos-control tcpfinurgpsh
Mode Global Config
no dos-control tcpfinurgpsh
This command sets disables TCP FIN and URG and PSH and SEQ=0 checking Denial of Service
protections. This command is only available on FSM72xxRS switches.
Format
no dos-control tcpfinurgpsh
Mode Global Config

dos-control icmpv4

This command enables Maximum ICMPv4 Packet Size Denial of Service protections. If the mode
is enabled, Denial of Service prevention is active for this type of attack. If ICMPv4 Echo Request
(PING) packets ingress having a size greater than the configured value, the packets will be
dropped if the mode is enabled. This command is only available on FSM72xxRS switches.
Default disabled <512>
Format
dos-control icmpv4 <0-16384>
Mode Global Config
no dos-control icmpv4
This command disables Maximum ICMP Packet Size Denial of Service protections. This
command is only available on FSM72xxRS switches.
Format
no dos-control icmpv4
Mode Global Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
dos-control icmpv4
v1.0, May 2010
3-188