NETGEAR ProSafe GSM7228PS Cli Manual page 429

no transport output telnet
Use this command to prevent new outbound Telnet connection from being established.
Format
no transport output telnet
Mode Line Config
session-limit
This command specifies the maximum number of simultaneous outbound Telnet sessions. A value
of 0 indicates that no outbound Telnet session can be established.
Default 5
Format
session-limit <0-5>
Mode Line Config
no session-limit
This command sets the maximum number of simultaneous outbound Telnet sessions to the default
value.
Format
no session-limit
Mode Line Config
session-timeout
This command sets the Telnet session timeout value.The timeout value unit of time is minutes.
Default 5
Format
session-timeout <1-160>
Mode Line Config
Management Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
8-13