Dhcp And Bootp Relay Commands; Bootpdhcprelay Cidoptmode - NETGEAR ProSafe GSM7228PS Cli Manual

Term Definition
MAC Address The MAC Address associated with the internal bridge-router interface (IBRI). The same
used by Routing
MAC Address is used by all VLAN routing interfaces. It will be displayed above the per-
VLANs
VLAN information.
VLAN ID The identifier of the VLAN.
Logical Interface The logical unit/slot/port associated with the VLAN routing interface.
IP Address The IP address associated with this VLAN.
Subnet Mask The subnet mask that is associated with this VLAN.

DHCP and BOOTP Relay Commands

This section describes the commands you use to configure BootP/DHCP Relay on the switch. A
DHCP relay agent operates at Layer 3 and forwards DHCP requests and replies between clients
and servers when they are not on the same physical subnet.

bootpdhcprelay cidoptmode

This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default disabled
Format
bootpdhcprelay cidoptmode
Mode Global Config
no bootpdhcprelay cidoptmode
This command disables the circuit ID option mode for BootP/DHCP Relay on the system.
Format
no bootpdhcprelay cidoptmode
Mode Global Config
Routing Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
4-21