NETGEAR ProSafe GSM7228PS Cli Manual page 126

7200 series managed switch cli refernce manual for software version 8.0.3
Hide thumbs Also See for ProSafe GSM7228PS:
Table of Contents

Advertisement

no storm-control unicast rate
This command sets the multicast storm recovery threshold to the default value for an interface and
disables multicast storm recovery.
Format
no storm-control unicast rate
Mode
Global Config
storm-control flowcontrol
This command enables 802.3x flow control for the switch and only applies to full-duplex mode
ports.
Note: 802.3x flow control works by pausing a port when the port becomes
oversubscribed and dropping all traffic for small bursts of time during the
congestion condition. This can lead to high-priority and/or network control traffic
loss.
Default
disabled
Format
storm-control flowcontrol
Mode
Global Config
no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Format
no storm-control flowcontrol
Mode
Global Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-88

Advertisement

Table of Contents
loading

Table of Contents