O/S Support - NETGEAR ProSafe GSM7228PS Cli Manual

Table 9-52: System General Error Messages
Component Message
OS USL: failed to sync initiator table on unit=x
OS USL: failed to sync terminator table on
unit=x
OS USL: failed to sync ip-multicast table on
unit=x

O/S Support

Table 9-53: OSAPI Log Messages
Component Message
OSAPI ftruncate failed – File resides on a read-only
file system.
OSAPI ftruncate failed – File is open for reading
only.
OSAPI ftruncate failed – File descriptor refers to a
file on which this operation is impossible.
OSAPI ftruncate failed – Returned an unknown
code in errno.
OSAPI ping: bad host!
OSAPI osapiTaskDelete: Failed for (XX) error YYY The requested task can not be deleted
Log Messages
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
Cause
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Could not synchronize unit x due to a
transport failure or API issue on remote unit.
A synchronization retry will be issued
Cause
ftruncate is called to correctly set the file's
size in the file system after a write. The file
system is R/W so this msg indicates the file
system may be corrupted.
ftruncate is called to correctly set the file's
size in the file system after a write. The file is
opened for R/W so this msg indicates the file
system may be corrupted.
ftruncate is called to correctly set the file's
size in the file system after a write. This msg
indicates the file system may be corrupted.
ftruncate is called to correctly set the file's
size in the file system after a write. This msg
indicates the file system may be corrupted.
The address requested to ping can not be
converted to an Internet address.
because: the requested deletion is called
from an ISR, the task is already deleted, or
the task ID is invalid.
9-26