NETGEAR ProSafe GSM7228PS Cli Manual page 144

hashing-mode
This command sets the hashing algorithm on Trunk ports. The command is available in the
interface configuration mode for a port-channel. The mode range is in the range 1-6 as follows:
1. Source MAC, VLAN, EtherType, and port ID
2. Destination MAC, VLAN, EtherType, and port ID
3. Source IP and source TCP/UDP port
4. Destination IP and destination TCP/UDP port
5. Source/Destination MAC, VLAN, EtherType and port
6. Source/Destination IP and source/destination TCP/UDP port
Default 3
Format
hashing-mode <mode>
Mode Interface Config
no hashing-mode
This command sets the hashing algorithm on Trunk ports to default (3). The command is available
in the interface configuration mode for a port-channel.
Format
no hashing-mode
Mode Interface Config
port-channel load-balance
This command selects the load-balancing option used on a port-channel (LAG). Traffic is
balanced on a port-channel (LAG) by selecting one of the links in the channel over which to
transmit specific packets. The link is selected by creating a binary pattern from selected fields in a
packet, and associating that pattern with a particular link.
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-106