NETGEAR ProSafe GSM7228PS Cli Manual page 22

Table 6. CLI Mode Access and Exit (continued)
Command Mode Access Method
Class-Map From the Global Config mode,
Config enter
class-map, and specify the
optional keyword ipv4 to specify
the Layer 3 protocol for this class.
See
more information.
Ipv6-Class-Map From the Global Config mode,
Config enter
class-map and specify the
optional keyword ipv6 to specify
the Layer 3 protocol for this class.
See
more information.
Router OSPF From the Global Config mode,
Config enter
router ospf.
Router OSPFv3 From the Global Config mode,
Config enter
ipv6 router ospf.
Router RIP From the Global Config mode,
Config enter
router rip.
Router BGP From the Global Config mode,
Config enter
router bgp <asnumber>.
MAC Access-list From the Global Config mode,
Config enter
mac access-list extended
<name>.
TACACS Config From the Global Config mode,
enter tacacs-server host
<ip-addr>, where <ip-addr> is
the IP address of the TACACS
server on your network.
DHCP Pool From the Global Config mode,
Config enter
ip dhcp pool <pool-name>.
Using the Command-Line Interface
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
"class-map" on page 6-10
"class-map" on page 6-10
v1.0, May 2010
Exit or Access Previous Mode
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
for
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
for
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
To exit to the Global Config mode, enter exit. To
return to the Privileged EXEC mode, enter Ctrl-
Z.
1-8