NETGEAR ProSafe GSM7228PS Cli Manual page 112

Term Definition
Maximum Users The maximum number of clients that can get authenticated on the port in the MAC-based
dot1x authentication mode. This value is used only when the port control mode is not
MAC-based.
Unauthenticate Indicates the unauthenticated VLAN configured for this port. This value is valid for the
d VLAN ID
port only when the port control mode is not MAC-based.
Session Indicates the time for which the given session is valid. The time period in seconds is
Timeout
returned by the RADIUS server on authentication of the port. This value is valid for the
port only when the port control mode is not MAC-based.
Session This value indicates the action to be taken once the session timeout expires. Possible
Termination
values are Default, Radius-Request. If the value is Default, the session is terminated the
Action
port goes into unauthorized state. If the value is Radius-Request, then a reauthentication
of the client authenticated on the port is performed. This value is valid for the port only
when the port control mode is not MAC-based.
The
show dot1x detail <unit/slot/port>
based dot1x fields if the port-control mode for that specific port is MAC-based. For each client
authenticated on the port, the
the following MAC-based dot1x parameters if the port-control mode for that specific port is MAC-
based.
Term Definition
Supplicant The MAC-address of the supplicant.
MAC-Address
Authenticator Current state of the authenticator PAE state machine. Possible values are Initialize,
PAE State
Disconnected, Connecting, Authenticating, Authenticated, Aborting, Held,
ForceAuthorized, and ForceUnauthorized.
Backend Current state of the backend authentication state machine. Possible values are Request,
Authentication
Response, Success, Fail, Timeout, Idle, and Initialize.
State
VLAN-Assigned The VLAN assigned to the client by the radius server.
Logical Port The logical port number associated with the client.
If you use the optional parameter statistics <unit/slot/port>, the following dot1x
statistics for the specified port appear.
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
show dot1x detail <unit/slot/port>
v1.0, May 2010
command will display the following MAC-
command will display
3-74