Snmp Trap Link-Status All - NETGEAR ProSafe GSM7228PS Cli Manual

Format
snmp trap link-status
Mode Interface Config
no snmp trap link-status
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
Format
no snmp trap link-status
Mode Interface Config

snmp trap link-status all

This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
server enable traps linkmode" on page 8-45
Format
snmp trap link-status all
Mode Global Config
no snmp trap link-status all
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
server enable traps linkmode" on page 8-45
Format
no snmp trap link-status all
Mode Global Config
Management Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
"snmp-
"snmp-
8-49