Lldp Transmit-Mgmt; Lldp Notification - NETGEAR ProSafe GSM7228PS Cli Manual

no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without
parameters to remove all optional TLVs from the LLDPDU.
Format
no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode Interface Config

lldp transmit-mgmt

Use this command to include transmission of the local system management address information in
the LLDPDUs.
Default enabled
Format
lldp transmit-mgmt
Mode Interface Config
no lldp transmit-mgmt
Use this command to include transmission of the local system management address information in
the LLDPDUs. Use this command to cancel inclusion of the management information in
LLDPDUs.
Format
no lldp transmit-mgmt
Mode Interface Config

lldp notification

Use this command to enable remote data change notifications.
Default disabled
Format
lldp notification
Mode Interface Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-160