NETGEAR ProSafe GSM7228PS Cli Manual page 371

domain-name
This command specifies the domain name for a DHCP client. The <domain> specifies the
domain name string of the client.
Default none
Format
domain-name <domain>
Mode DHCP Pool Config
no domain-name
This command removes the domain name.
Format
no domain-name
Mode DHCP Pool Config
netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name servers that
are available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one command line.
Servers are listed in order of preference (address1 is the most preferred server, address2 is the next
most preferred server, and so on).
Default none
Format
netbios-name-server <address> [<address2>...<address8>]
Mode DHCP Pool Config
no netbios-name-server
This command removes the NetBIOS name server list.
Format
no netbios-name-server
Mode DHCP Pool Config
Utility Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
7-45