NETGEAR ProSafe GSM7228PS Cli Manual page 252

Term Definition
Routing Determine the operational status of IPv4 routing Interface. The possible values are Up or
Interface Status
Down.
Primary IP The primary IP address and subnet masks for the interface. This value appears only if you
Address
configure it.
Secondary IP One or more secondary IP addresses and subnet masks for the interface. This value
Address
appears only if you configure it.
Helper IP The helper IP addresses configured by the
Address
Routing Mode The administrative mode of router interface participation. The possible values are enable
or disable. This value is configurable.
Administrative The administrative mode of the specified interface. The possible values of this field are
Mode
enable or disable. This value is configurable.
Forward Net Displays whether forwarding of network-directed broadcasts is enabled or disabled. This
Directed
value is configurable.
Broadcasts
Proxy ARP Displays whether Proxy ARP is enabled or disabled on the system.
Local Proxy ARP Displays whether Local Proxy ARP is enabled or disabled on the interface.
Active State Displays whether the interface is active or inactive. An interface is considered active if its
link is up and it is in forwarding state.
Link Speed Data An integer representing the physical link data rate of the specified interface. This is
Rate
measured in Megabits per second (Mbps).
MAC Address The burned in physical address of the specified interface. The format is 6 two-digit
hexadecimal numbers that are separated by colons.
Encapsulation The encapsulation type for the specified interface. The types are: Ethernet or SNAP.
Type
IP MTU The maximum transmission unit (MTU) size of a frame, in bytes.
Bandwidth Shows the bandwidth of the interface.
Destination Displays whether ICMP Destination Unreachables may be sent (enabled or disabled).
Unreachables
ICMP Redirects Displays whether ICMP Redirects may be sent (enabled or disabled).
The following shows example CLI display output for the command.
(switch)#show ip interface 1/0/2
Routing Interface Status....................... Down
Primary IP Address............................. 1.2.3.4/255.255.255.0
Secondary IP Address(es)....................... 21.2.3.4/255.255.255.0
............................................... 22.2.3.4/255.255.255.0
Helper IP Address.............................. 1.2.3.4
............................................... 1.2.3.5
Routing Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
"ip helper-address (Global Config)command.
4-15