NETGEAR ProSafe GSM7228PS Cli Manual page 75

vlan protocol group add protocol
This command adds the <protocol> to the protocol-based VLAN identified by <groupid>.
A group may have more than one protocol associated with it. Each interface and protocol
combination can only be associated with one group. If adding a protocol to a group causes any
conflicts with interfaces currently associated with the group, this command fails and the protocol
is not added to the group. The possible values for protocol are ip, arp, and ipx.
Default none
Format
vlan protocol group add protocol <groupid> <protocol>
Mode Global Config
no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is
identified by this <groupid>. The possible values for protocol are ip, arp, and ipx.
Format
no vlan protocol group add protocol <groupid> <protocol>
Mode Global Config
vlan protocol group remove
This command removes the protocol-based VLAN group that is identified by this <groupid>.
Format
vlan protocol group remove <groupid>
Mode Global Config
protocol group
This command attaches a <vlanid> to the protocol-based VLAN identified by <groupid>.
A group may only be associated with one VLAN at a time, however the VLAN association can be
changed.
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-37