NETGEAR ProSafe GSM7228PS Cli Manual page 503

7200 series managed switch cli refernce manual for software version 8.0.3
Hide thumbs Also See for ProSafe GSM7228PS:
Table of Contents

Advertisement

Table 9-23: IGMP Snooping Log Messages
Component
Message
IGMP Snooping Failed to set igmp mrouter mode %d for
interface xxx on Vlan yyy
IGMP Snooping snoopCnfgrInitPhase1Process: Error
allocating small buffers
IGMP Snooping snoopCnfgrInitPhase1Process: Error
allocating large buffers
Table 9-24: GARP/GVRP/GMRP Log Messages
Component
Message
GARP/GVRP/
garpSpanState, garpIfStateChange,
GarpIssueCmd, garpDot1sChangeCallBack,
GMRP
garpApiCnfgrCommand,
garpLeaveAllTimerCallback,
garpTimerCallback: QUEUE SEND
FAILURE:
GARP/GVRP/
GarpSendPDU: QUEUE SEND FAILURE
GMRP
GARP/GVRP/
garpMapIntfIsConfigurable,
gmrpMapIntfIsConfigurable: Error accessing
GMRP
GARP/GMRP config data for interface %d in
garpMapIntfIsConfigurable.
GARP/GVRP/
garpTraceMsgQueueUsage: garpQueue
usage has exceeded fifty/eighty/ninety
GMRP
percent
GARP/GVRP/
gid_destroy_port: Error Removing port %d
registration for vlan-mac %d -
GMRP
%02X:%02X:%02X:%02X:%02X:%02X
GARP/GVRP/
gmd_create_entry: GMRP failure adding
MFDB entry: vlan %d and address %s
GMRP
Table 9-25: 802.3ad Log Messages
Component
Message
802.3ad
dot3adReceiveMachine: received default
event %x
Log Messages
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
Cause
Failed to set VLAN multicast router mode
due to IGMP Snooping message queue
being full
Could not allocate buffers for small IGMP
packets
Could not allocate buffers for large IGMP
packets
Cause
The garpQueue is full, logs specifics of the
message content like internal interface
number, type of message etc.
The garpPduQueue is full, logs specific of
the GPDU, internal interface number, vlan
id, buffer handle etc.
A default configuration does not exist for this
interface. Typically a case when a new
interface is created and has no pre-
configuration.
Traces the build up of message queue.
Helpful in determining the load on GARP.
Mismatch between the gmd (gmrp
database) and MFDB.
MFDB table is full.
Cause
Received a LAG PDU and the RX state
machine is ignoring this LAGPDU
9-13

Advertisement

Table of Contents
loading

Table of Contents