NETGEAR ProSafe GSM7228PS Cli Manual page 128

shares traffic based upon the source and destination MAC address.Assign the port-channel (LAG)
VLAN membership after you create a port-channel. If you do not assign VLAN membership, the
port-channel might become a member of the management VLAN which can result in learning and
switching issues.
A port-channel (LAG) interface can be either static or dynamic, but not both. All members of a
port channel must participate in the same protocols.) A static port-channel interface does not
require a partner system to be able to aggregate its member ports.
Note: If you configure the maximum number of dynamic port-channels (LAGs) that your
platform supports, additional port-channels that you configure are automatically
static.
port-channel
This command configures a new port-channel (LAG) and generates a logical unit/slot/port number
for the port-channel. The <name> field is a character string which allows the dash "-" character as
well as alphanumeric characters. Use the show port channel command to display the unit/
slot/port number for the logical interface.
Note: Before you include a port in a port-channel, set the port physical mode. For more
information, see
Format
port-channel <name>
Mode Global Config
no port-channel
This command deletes a port-channel (LAG).
Format
no port-channel {<logical unit/slot/port> | all}
Mode Global Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
"speed" on page 3-7.
v1.0, May 2010
3-90