Show Lldp Med - NETGEAR ProSafe GSM7228PS Cli Manual

no lldp med transmit-tlv
Use this command to remove a TLV.
Format
no lldp med transmit-tlv all [capabilities] [network-policy] [ex-pse]
[ex-pd] [location] [inventory]
Mode Global Config

show lldp med

Use this command to display a summary of the current LLDP MED configuration.
Format
show lldp med
Mode Privileged Exec
Term Definition
Fast Start The number of LLDP PDUs that will be transmitted when the protocl is enabled.
Repeat Count
Device Class The local device's MED Classification. There are four different kinds of devices, three of
them represent the actual end points (classified as Class I Generic[IP Communication
Controller etc.], Class II Media Conference Bridge etc.], Class III Communication [IP
Telephone etc.]. Class IV Network Connectivity Device, which is typically a LAN Switch,
Router, IEEE 802.11 Wireless Access Point, etc.
Example: The following shows example CLI display output for the command.
(switch) #show lldp med
LLDP MED Global Configuration
Fast Start Repeat Count:
Device Class: Network Connectivity
(switch) #
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
3
v1.0, May 2010
3-172