Set Igmp Querier Version; Set Igmp Querier Election Participate - NETGEAR ProSafe GSM7228PS Cli Manual

set igmp querier version

Use this command to set the IGMP version of the query that the snooping switch is going to send
periodically.
Default 1
Format
set igmp querier version <1-2>
Mode Global Config
no set igmp querier version
Use this command to set the IGMP Querier version to its default value.
Format
no set igmp querier version
Mode Global Config

set igmp querier election participate

Use this command to enable the Snooping Querier to participate in the Querier Election process
when it discovers the presence of another Querier in the VLAN. When this mode is enabled, if the
Snooping Querier finds that the other Querier's source address is better (less) than the Snooping
Querier's address, it stops sending periodic queries. If the Snooping Querier wins the election,
then it will continue sending periodic queries.
Default disabled
Format
set igmp querier election participate
Mode VLAN Config
no set igmp querier election participate
Use this command to set the Snooping Querier not to participate in querier election but go into
non-querier mode as soon as it discovers the presence of another querier in the same VLAN.
Format
no set igmp querier election participate
Mode VLAN Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-150