NETGEAR ProSafe GSM7228PS Cli Manual page 367

client-name
This command specifies the name for a DHCP client. Name is a string consisting of standard
ASCII characters.
Default none
Format
client-name <name>
Mode DHCP Pool Config
no client-name
This command removes the client name.
Format
no client-name
Mode DHCP Pool Config
default-router
This command specifies the default router list for a DHCP client. {address1, address2...
address8} are valid IP addresses, each made up of four decimal bytes ranging from 0 to 255. IP
address 0.0.0.0 is invalid.
Default none
Format
default-router <address1> [<address2>....<address8>]
Mode DHCP Pool Config
no default-router
This command removes the default router list.
Format
no default-router
Mode DHCP Pool Config
Utility Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
7-41