NETGEAR ProSafe GSM7228PS Cli Manual page 322

Note: An implicit 'deny all' IPv6 rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a
minimum, either the 'every' keyword or the protocol, source address, and destination address
values must be specified. The source and destination IPv6 address fields may be specified using
the keyword 'any' to indicate a match on any value in that field. The remaining command
parameters are all optional, but the most frequently used parameters appear in the same relative
order as shown in the command format.
The assign-queue parameter allows specification of a particular hardware queue for handling
traffic that matches this rule. The allowed <queue-id> value is 0-(n-1), where n is the number
of user configurable queues available for the hardware platform. The assign-queue parameter
is valid only for a permit rule.
The mirror parameter allows the traffic matching this rule to be copied to the specified <unit/
slot/port>, while the redirect parameter allows the traffic matching this rule to be forwarded
to the specified <unit/slot/port>. The assign-queue and redirect parameters are
only valid for a permit rule.
Format
{deny | permit} {every | {{icmp | igmp | ipv6 | tcp | udp |
<number>}[log] [assign-queue <queue-id>] [{mirror | redirect} <unit/
slot/port>]
Mode IPv6-Access-List Config
ipv6 traffic-filter
This command either attaches a specific IPv6 ACL identified by <name> to an interface or
associates with a VLAN ID in a given direction. The <name> parameter must be the name of an
existing IPv6 ACL.
An optional sequence number may be specified to indicate the order of this mac access list relative
to other IPv6 access lists already assigned to this interface and direction. A lower number indicates
higher precedence order. If a sequence number is already in use for this interface and direction, the
specifiedIPv6 access list replaces the currently attached IPv6 access list using that sequence
number. If the sequence number is not specified for this command, a sequence number that is one
greater than the highest sequence number currently in use for this interface and direction is used.
Quality of Service (QoS) Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
6-46