Novell NETWARE 6-DOCUMENTATION Manual page 1927

4
Modify the filter list.
Select a filter from the list and press Enter to modify the filter or Del to
remove it. Press Ins to add a new filter.
If you are modifying an existing filter or adding a filter, specify the
following parameters in the Define Filter menu:
Route to Network (or Route to Network or Zone )—Select All
Routes , Non-extended Network , Multiple/Extended Network , or
Zone as the type of route or network to be filtered.
Network Number/Range —Enter a network number or a network
range, depending on whether you selected a nonextended or an
extended network. If you select an extended network, you can enter
a single extended network or a range of extended and nonextended
networks.
Zone Name (Outgoing only)—Enter the zone name of the
AppleTalk zone to be filtered.
Source (or Destination ) Type —Press Enter and select Interface ,
Interface Group , or AURP Tunnel .
Source (or Destination )—Press Enter and select the interface or
interface group from the list. This option does not apply for an AURP
tunnel.
If you specified Interface as the Source Type , select a specific
interface on which you want to filter the service. You can select a
LAN interface, a WAN interface, the internal network, or all
interfaces. The default is All Interfaces .
Source (or Destination ) Circuit —If you selected a WAN circuit,
press Enter to modify the following optional circuit information:
Local Frame Relay DLCI # (for frame relay)—The DLCI circuit
number used for calls.
Remote System ID (for PPP, X.25, ISDN, or ATM)—The name of
the remote system server or remote peer associated with this circuit.
Circuit Parameter Type (for X.25 or ATM)—The type of virtual
circuit used to establish a connection.
Remote DTE Address (for X.25)—The X.121 DTE address assigned
to the specific remote DTE.
Remote ATM Address (for ATM)—The address assigned to the
specific remote ATM.
Comment —Enter an optional short description.
67
Setting Up